![]() 7: Example of a completely crimped female contact. 6: Example of a completely crimped male contact. The higher level crimps more forcefully and is used for wires while the lower level provides lower force and fixes the isolation. 5: Contact should be positioned along the two different levels of the crimping tool, as shown here. 4: Position the contact inside the crimping tool as shown. Two examples for incorrect crimping: Example 1:Isolation must not be outside of crimped area.Įxample 2:Wire must not protrude forward from the crimped area. The cable must not disconnect from the contact. Check in advance if the contact is crimped correctly by pulling the cable. The most common source for problems is a badly crimped contact. 3: Repeat this process for the female contact. Check if the wire is of correct length and does not protrude the crimped area. Make sure the isolation reaches up to the central notch. 2: Crimp the wire as shown in the picture. ![]() If too much isolation has been removed the contact can no longer be inserted into the housing. ![]() Make sure the uncovered wires are not longer than 3mm. 1: First, remove the isolation from the wire. How to install JST connectors(shown here with 4-pin connector) The appropriate amount of contacts for plug-inĬables can either be soldered or crimped.ġx crimping tool for JST connectors (see shop: aejstcrimp02). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |